Effect Capable Solid State Outputs
The Kore Effects + comes with 8 solid-state outputs capable of powering 12V or 24V devices depending on your power source. All of the solid state outputs are capable of switching a maximum current of 500mA each. If you need to switch 120/240V AC or more than 500mA per channel be sure to check out our scare packs!
The Kore Effects + has built in digital volume control and comes equipped with an onboard audio amplifier capable of driving two speakers!
The Kore Effects + supports MP3 Audio Playback. There is no limit to the length of the MP3 to be played.
Scare Scene Trigger
The Kore Effects + has a trigger input which can be used with any L2S trigger. A scene can also be triggered using the on-board buttons.
The Kore Effects + features Idle Mode, which plays a pre-recorded scene while the controller is not playing its Scare Scene. Idle Mode has full scene playback functionality, including outputs, effects, and MP3 audio. Click here for tutorials on Idle Mode.
The Kore Effects + has a slot for a Micro SD Card which is used as memory for the device. Scenes and MP3s can be any length, you're only limited by the size of the SD Card being used.
The Kore Effects + can be programmed with our KoreLink Desktop Software when connected via the Kore Effects Programming Cable. Our software allows you to create simple or complex scenes, then upload the scene to Kore Effects +. Scenes can be played back in multiple modes which allow you to perfect your Scene's timing easier than ever before! Click here for tutorials on KoreLink Programming.
The Kore Effects + features 5 on-board buttons for programming and configuring scenes right on the device! Four status LEDs are included with the to allow all features using on-board programming! All 8 solid state outputs and 4 effect capable outputs can be programmed using on-board buttons. Click here for tutorials on Kore Effects + On-Board Programming.